Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
CWS Driveway & Pavers: The Houston Owner’s Guide
If you have a CWS driveway or paver installation that’s cracking, sinking, or separating, we stock and install CWS-compatible driveway and paver materials here in Houston. A full paver driveway replacement typically runs $7,000–$18,000 installed, while targeted repairs to a failing section usually come in well under that depending on square footage and what’s happening underneath. Most Houston owners notice the problem first as a low spot that pools water after a hard rain, or an edge paver that’s started to tip. Those are early warning signs, and they rarely fix themselves.
Which CWS Models This Applies To
CWS driveway and paver systems are built around specific paver dimensions and joint tolerances, so matching the right material matters more than most homeowners expect. The key identifier is the paver thickness: CWS residential driveways typically use 60mm or 80mm pavers, while walkways and patios often step down to 40mm. If you can see an exposed edge anywhere—along a driveway border or where the pavers meet a sidewalk—measure the thickness with a tape measure before you call. We also ask about the original installation date and whether the base was documented at the time of install, because a 60mm paver over a proper crushed-stone base behaves very differently in Houston clay than the same paver over sand.
As an independent Houston contractor, we’re not affiliated with CWS, but we work with CWS pavers and compatible aftermarket equivalents every week. The decision between OEM CWS pavers and a quality aftermarket match usually comes down to age: if your CWS installation is under ten years old, the original paver is likely still in production and we can match color and texture closely. If it’s older or the line has been discontinued, a measured aftermarket match keeps the cost reasonable without a full tear-out.
Styles & brands we work with
Signs Your CWS Driveway & Pavers Is Failing
- Water pooling in low spots after rain. This usually means the base under the pavers has started to erode or compact unevenly. In Houston’s expansive clay soil, the ground swells when wet and shrinks when dry, which slowly deforms even a well-built paver base.
- Edge pavers tipping or separating from the border. The edge restraint is the first thing to fail on many CWS installations. Once the border stops holding, the outside pavers start to drift outward, and the gap grows every time a car rolls over the edge.
- Cracks running through individual pavers. A cracked paver is usually a stress point: tree roots, a heavy vehicle parked in one spot repeatedly, or a base void underneath. One cracked paver is a repair. Five cracked pavers in a pattern is a base problem.
- Sand washing out of the joints after every storm. Houston’s heavy downpours flush joint sand fast. When the joints stay empty, pavers shift against each other and start to chip. Re-sanding alone won’t fix the underlying cause if the base is shifting.
- A section that feels soft or spongy underfoot. If a paver moves when you step on it, you have a void in the base. That void will only grow, and continuing to drive over it turns a localized repair into a much larger replacement.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Here’s what we see across Houston for CWS-related work. A full paver driveway replacement runs $7,000–$18,000 depending on square footage, paver type, and whether the base needs to be re-excavated and rebuilt. A paver patio installation runs $3,500–$11,000. Sealing an existing driveway surfaces between $250–$700. Those ranges reflect what drives the number: base depth requirements for Houston clay, access to the site, whether we can salvage and reuse existing pavers, and the color and finish of the replacement material.
Every job gets a written price before any work starts, not a ballpark or an estimate you have to read between the lines on. The number on day one is the number on the invoice. And every CWS-related repair or replacement we do carries our 365-Day Done Right Promise in writing: if something fails inside a year, we come back and fix it at no charge. If a repair fails, the second visit is free, too. No service-call fee, no re-inspection charge.
DIY or Call Us?
There are things a Houston homeowner can safely check on their own. You can identify which pavers are cracked, measure their thickness at an exposed edge, and note where water pools after a storm. That information genuinely helps us price the job faster. What you should not do is start pulling pavers and rebuilding the base yourself, especially on a driveway. The base is the structural part of the system, and if you get the compaction or the drainage slope wrong on Houston clay, you’ll have the same failure again in two years, only now you’ve spent a weekend doing it. Trevor Nash has walked enough Houston job sites near Meyerland to know that the soil there does not forgive a shortcut. If the base is shot, that’s a professional repair. Call (254) 527-5340 and give me the straight story on what you’re seeing, and I’ll give you the straight number on what it costs to fix it right.
FAQs
A properly installed CWS paver driveway with a correct base lasts 20–30 years in Houston, with the paver surface itself often outlasting the base underneath it. Houston’s clay soil and heavy rains shorten that lifespan when the base was underbuilt, which is why we see many CWS installations failing at the 8–12 year mark. Call (254) 527-5340 for an exact assessment of your installation’s remaining life—estimates are free.
Yes, in most cases a localized failure—cracked pavers, a shifted section, or an edge that’s come loose—can be repaired without replacing the whole driveway. The exception is when the base has failed across a wide area, which is when you see multiple low spots and shifting across a large percentage of the surface. We’ll tell you which one you have after we look at it. Call (254) 527-5340 for a free estimate.
A typical section repair takes one to two days, depending on how much base prep is required and whether we need to source matching pavers. A full driveway replacement usually runs three to five days. We’ll give you a real arrival window before we start, and we hold to it. Call (254) 527-5340 to schedule your free estimate.
We keep the most common CWS-compatible paver profiles and colors in stock for Houston-area repairs, though uncommon colors or discontinued lines may need to be sourced to match your existing installation. We’ll verify availability before we quote the job so you’re never waiting on a price that depends on a part we can’t get. Call (254) 527-5340 for an exact quote—estimates are free.
Written by Trevor Nash, Owner, Penhallow Remodeling Houston at Penhallow Remodeling Houston, serving Houston and nearby areas.
